Installation Procedure
WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Install the brake pedal adjustment position sensor to the brake pedal bracket. Ensure the brake pedal position sensor tabs (1) lock into the brake pedal bracket and the sensors arm (2) is correctly installed.
- Install the electrical connector to the brake pedal adjustment position sensor.
- Install the steering wheel stub shaft to the steering column. Refer to Intermediate Steering Shaft Replacement in Steering Wheel and Column.
- Install the closeout panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
IMPORTANT:
Ensure that the brake pedal adjustment position sensor is installed correctly to the bracket. The brake pedal adjustment position sensor has a sensing arm that must be installed as shown in the picture to insure it is sensing brake pedal position.