LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 182 (Antilock Brake System, Traction Control System & Stability Control System) >> Diagnostic Information and Procedures >> DTC C0252 >> Test Description

Test Description

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  Perform the Steering Position Sensor Test in order to verify that the steering wheel position sensor (SWPS) is operating properly.
  2. 3:  Verify that the Lateral Accelerometer Signal parameter is within the valid range.
  3. 4:  Verify that the Yaw Rate Signal parameter is within the valid range.
DTC C0252

Step Action Values Yes No
Schematic Reference: Antilock Brake System Schematics 
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With the scan tool, perform the Steering Position Sensor Test.
Did the steering wheel position sensor (SWPS) pass the test?
- Go to Step 3  Go to Step 7 
With a scan tool, observe the Lateral Accelerometer Signal parameter in the Vehicle Stability Enhancement System (VSES) data list.
Does the scan tool display within the specified range?
2.3-2.7 V Go to Step 4  Go to Step 8 
With a scan tool, observe the Yaw Rate Signal parameter in the VSES data list.
Does the scan tool display within the specified range?
2.3-2.7 V Go to Step 5  Go to Step 8 
5
  1. Use the scan tool in order to clear the DTCs.
  2. Perform the Diagnostic Test Drive. Refer to Diagnostic Test Drive .
Does the DTC reset?
- Go to Step 6  Go to Diagnostic Aids
6 Replace the electronic brake control module (EBCM). Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?
- Go to Step 9  -
7 Replace the steering wheel position sensor (SWPS). Refer to Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement .
Did you complete the replacement?
- Go to Step 9  -
8 Replace the yaw rate/lateral accelerometer sensor. Refer to Yaw Rate Sensor/Lateral Accelerometer Replacement .
Did you complete the replacement?
- Go to Step 9  -
9
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?
- Go to Step 2  System OK