Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Receiver

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the receiver and secure with the fastener.
Tighten: Tighten the fastener to 3 N.m (26 lb in).

Fig 2: Disconnecting/Connecting Electrical Connectors At Receiver

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector to the receiver.
Install the rear compartment trim panel. Refer to Compartment Trim Panel Replacement - Rear in Body Rear End.
Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .