Installation Procedure
WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Clean around the edge of the inside surface of the window with a 50/50 mixture of isopropyl alcohol and water by volume on a dampened lint free cloth.
- Using a heat gun, ensure that the temperature of the window and the reveal molding is approximately 29-32°C (85-90°F).
- Apply masking tape around the window, 8 mm (0.31 in) from the window edge (A), as a guide for locating the window reveal molding.
- Remove the protective liner from the back of the window reveal moldings.
- Position the window reveal molding (3) to the location tape. Press the molding to the mounting surface.
- Apply equal pressure along the window reveal moldings to uniformly bond the molding to the window.
- Remove the tape from around the window.
- Install the roof window. Refer to Roof Window Replacement .
IMPORTANT:
Apply the window reveal moldings in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign material may cause improper adhesion.