LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Diagnostic Information And Procedures >> DTC B1516 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the battery current sensor.
  2. Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 ohms between the low reference circuit terminal B and ground.

    → If greater than the specified range, test the low reference circuit for an open/high resistance.

  3. Ignition ON, test for greater than 4.5 volts between the supply voltage circuit terminal A and ground.

    → If less than the specified range, disconnect the headlamp switch. If the circuit tests normal, replace the headlamp switch. Test the supply voltage circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.

  4. Ignition ON, test for greater than 4.5 volts between the signal circuit terminal C and ground.

    → If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.

  5. If all circuits test normal, replace the battery current sensor.
scientia non olet · About LEMON Manuals