Power Sliding Door Module Replacement

Replacement of the PSDM requires that the power sliding door system be disabled by removing the PSD 15-amp fuse. Once the PSDM has been replaced and the fuse installed, the following initialization procedure must be performed for both sliding doors in the following order:

1. Manually close and latch the power sliding doors.
2. Perform two complete Open/Closed cycles for each sliding door using any one of the following devices:
   • Appropriate switch mounted in the overhead console
   • Appropriate switch mounted to the B pillar
   • Remote Transmitter
   • Special functions of the scan tool
3. With a scan tool, verify that the PSD Open/Closed Position Learned parameter displays "Yes".
4. Operate the power sliding door to verify completion of the procedure. Refer to Power Sliding Door (PSD) Description and Operation in Doors.