Removal Procedure

Right side shown, left side similar.

1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 2  or to SIR Disabling and Enabling Zone 6 .
2. Remove the center pillar lower molding. Refer to Garnish Molding Replacement - Center Pillar Lower in Interior Trim.
Fig 1: Removing/Installing Side Impact Sensor
Courtesy of GENERAL MOTORS CORP.
3. Remove the side impact sensor fasteners.
4. Remove the side impact sensor.
5. Remove the CPA and disconnect the electrical connector to the side impact sensor.