LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2005 >> L300 >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Inflatable Restraint Side Impact Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Side Impact Sensor
    GM898003Courtesy of GENERAL MOTORS CORP.
  1. Finger start the fasteners to the side impact sensor.
  2. Connect the electrical connector to the side impact sensor and insert the CPA to secure.
  3. Place the side impact sensor through the access hole in the B-Pillar.
  4. Move the module up and locate the captured fastener through the key slots in the B-pillar.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Secure the captured fasteners in the side impact sensor.

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in).

  6. Install the center pillar lower molding. Refer to Garnish Molding Replacement - Center Pillar Lower .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2  or to SIR Disabling and Enabling Zone 6 .
scientia non olet · About LEMON Manuals