LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2005 >> L300 >> Repair and Diagnosis >> Brakes >> Antilock Brake System And Traction Control System >> Diagnostic Information And Procedures >> DTC C0121 >> Test Description

Test Description

The number below refers to step number on the diagnostic table.

  1. 2:  This step determines if the DTC is current.
DTC C0121

Step Action Yes No
Schematic Reference: ABS Schematics 
Connector End View Reference: ABS Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. Use the scan tool in order to clear the DTCs.
Does the DTC reset?		 Go to Step 3  Go to Diagnostic Aids
3
  1. Disconnect the electronic brake control module (EBCM) harness connector.
  2. Test the battery positive voltage circuit for an open, high resistance, or a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 5  Go to Step 4 
4 Replace the EBCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 5  -
5
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals