LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2005 >> Ion 1 Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Diagnostic Information & Procedures >> Diagnostic Information & Procedures >> Scan Tool Data List

Scan Tool Data List

The Engine Scan Tool Data List contains all engine related parameters that are available on the scan tool. The list is arranged in alphabetical order. A given parameter may appear in any one of the data lists, and in some cases may appear more than once, or in more than one data list in order to group certain related parameters together.

Use the Engine Scan Tool Data List only after the following is determined:

Scan tool values from a properly running engine may be used for comparison with the engine you are diagnosing. The Engine Scan Tool Data List represents values that would be seen on a normal running engine.

IMPORTANT: A scan tool that displays faulty data should not be used. The scan tool problem should be reported to the manufacturer. Use of a faulty scan tool can result in misdiagnosis and unnecessary parts replacement.

Only the parameters listed below are referenced in this service manual for use in diagnosis. If all values are within the typical range described below, refer to Symptoms - Engine Controls for diagnosis.

The column labeled Data List indicates where a parameter can be located on the scan tool. Refer to the scan tool operating manual for the exact locations of the data lists. The following is a description of each term listed:

All

The Parameter is in all of the data lists indicated below.

ED

Engine Data

EVAP

EVAP Data

FT

Fuel Trim Data List

MF

Misfire Data List

TAC

Throttle Actuated Control Data List

HO2S

HO2S Data

ID

Ignition Data

Scan Tool Data List

Scan Tool Parameter Data List Parameter Range/Units Typical Data Values
Engine Idling/Radiator Hose Hot/Closed Throttle/Park or Neutral/Closed Loop/Accessories Off
A/C Relay Command ED, MF, TAC On/Off Off
Air Fuel Ratio ED, FT, HO2S Ratio 14.7:1
APP Indicated Angle ED, EVAP, FT, HO2S, MF, TAC, ID 0-96% 0%
APP Sensor 1 TAC %/Volts 0%/1.02 Volts
APP Sensor 1 TAC Degrees 0%
APP Sensor 2 TAC %/Volts 0%/4.04 Volts
APP Sensor 2 TAC Degrees 0%
APP Sensor 1 and 2 TAC Agree/Disagree Agree
APP Sensor 1 Circuit TAC OK/Fault OK
APP Sensor 2 Circuit TAC OK/Fault OK
BARO ED, EVAP, FT, HO2S, ID kPa 65-104 kPa/ Varies w/Altitude
Catalytic Converter Protection Active FT, HO2S Yes/No No
CKP Active Counter ID 1-250 9-250
CKP Resync Counter ID Counts -
CKP Sensor ED, ID RPM -
Clutch Pedal Switch 2 ED, TAC - -
Cold Start-Up ED, EVAP Varies Varies
Cycles of Misfire Data MF 0-100 Counts Varies
Decel Fuel Cutoff ED, FT, HO2S Active/Inactive Inactive
Desired Idle Speed ED, EVAP, TAC RPM PCM Controlled
Engine OFF Time EVAP - -
ECM Reset ED, EVAP, ID - -
ECT Sensor ED, EVAP, FT, HO2S, ID, MF, TAC, HVAC -40 to -40°C (+151 to +303°F) 88-105°C (190-221°F) Depends on ambient temperature
Engine OFF Time EVAP - -
Engine Load ED, EVAP, FT, HO2S, ID, MF, TAC 0-100% 23-24% @ Idle
7-42% @ 2500 RPM
Engine Oil Level Switch ED - -
Engine Oil Pressure Switch ED, MF OK/Low OK
Engine Run Time ED, EVAP, HO2S, ID, MF, TAC Hrs, Min, Sec Varies
Engine Speed ED, EVAP, FT, HO2S, ID, MF, TAC 0-10,000 RPM 500-700 RPM
EVAP Purge Solenoid Command ED, EVAP, FT, HO2S 0-100% 10-30%
EVAP Vent Solenoid Command ED, EVAP Not Venting/Venting Venting
Fuel Tank Level Remaining ED, EVAP, MF % Varies
Fuel Tank Level Remaining ED Liters Varies
Fuel Tank Pressure Sensor ED, EVAP mm/Hg / In H2O Varies
Fuel Tank Pressure Sensor EVAP mm/Hg / In H2O/Volts Varies
Fuel Trim Cell ED, EVAP, FT 0-23 16, 17, 21
Fuel Trim Learn ED, EVAP, FT Able/Disable Disabled
Fuel Pump Relay Command ED, FT On/Off On
HO2S 1 ED, EVAP, FT, HO2S mV 10-1,000 mV and Varying
HO2S 2 ED, FT, HO2S mV 10-1,000 mV and Varying
HO2S 1 Heater Current HO2S Amps Varies
HO2S 2 Heater Current HO2S Amps Varies
Hot Open Loop FT, HO2S - -
IAT Sensor ED, EVAP, FT, ID, MF, HO2S, TAC -40 to +151°C (-40 to +303°F) Depends on ambient temperature
Ignition Accessory Signal ED, TAC On/Off Off
Ignition 1 Signal ED, EVAP, FT, HO2S, ID, MF, TAC 0-25 volts 11.5-14.5 Volts
Injector PWM FT, HO2S Milliseconds 2-6 ms
Long Term FT ED, EVAP, FT, HO2S % Near 0%
Loop Status ED, EVAP, FT, HO2S Open/Closed Closed
MAF Sensor ED, EVAP, FT, HO2S Hz Hz
MAF Sensor ED, EVAP, FT, HO2S, ID, TAC g/s Varies
MAP ED Volts -
MAP Sensor ED, EVAP, FT, HO2S, ID, MF, TAC kPa 20-48 kPa
MIL Command ED, EVAP, ID Off/On Off
MIL Requested By DTC ED, EVAP, ID - -
Misfire Current Cyl #1 MF Varies 0
Misfire Current Cyl #2 MF Varies 0
Misfire Current Cyl #3 MF Varies 0
Misfire Current Cyl #4 MF Varies 0
Misfire History Cyl #1 MF Varies 0
Misfire History Cyl #2 MF Varies 0
Misfire History Cyl #3 MF Varies 0
Misfire History Cyl #4 MF Varies 0
Power Enrichment ED, FT, HO2S, MF Active/Inactive Inactive
Reduced Engine Power TAC Active/Inactive Inactive
Short Term FT ED, EVAP, FT, HO2S % Near 0%
Spark ED, FT, HO2S, ID, MF Degrees 11-20°
Start Up ECT EVAP, FT, HO2S °C/°F Varies
Start Up IAT EVAP, FT, HO2S °C/°F Varies
TAC Forced Engine Shutdown TAC - -
TAC Motor TAC - -
TCC Cruise Brake Pedal ED, TAC - -
Total Knock Retard ID Agrees -
Total Misfire Count MF Count 0
Torque Delivered Signal TAC N.m Varies
TP Indicated Angle ED, EVAP, FT, HO2S, ID, MF, TAC % 4.2%
TP Sensors 1 and 2 TAC Agree/Disagree Agree
TP Sensor 1 TAC 0-100% 4%
TP Sensor 2 TAC 0-100% 4%
TP Sensor 1 TAC 0-5.0 volts 4.24 volts
TP Sensor 2 TAC 0-5.0 volts 0.78 volts
Traction Control Status TAC Active/Inactive Inactive
TWC Temperature Calculated MF, FT C/F 350°C
Vehicle Speed Sensor ED, EVAP, HO2S, ID, MF, FT, TAC km/h
mph
0
Wide Open Throttle TAC - -