LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2004 >> L300 4D Wagon, 2.2 F >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.2L (L61) (Introduction) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure

Installation Procedure

  1. Lubricate the CKP sensor O-ring with clean engine oil.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CKP sensor in the engine block and attachment bolt. Tighten:  Tighten the crankshaft position sensor bolt to 10 N.m (89 lb in).
  3. Connect the CKP sensor harness connector. Push in the connector until a click is heard, then pull back to confirm a positive engagement.
  4. Install the starter into the flywheel housing and align the bolt holes.
  5. Install the upper and lower starter assembly to the engine block bolts.Tighten:  Tighten the starter-to-engine bolts to 40 N.m (30 lb ft).
  6. Install the two starter solenoid harness connections and attachment nuts.
    1. Tighten: 
      • Tighten the starter solenoid harness nuts (large) to 9 N.m (80 lb in).
      • Tighten the starter solenoid harness nuts (small) to 3 N.m (27 lb in).
    7. Fig 1: Installing Starter Motor
    GM895784Courtesy of GENERAL MOTORS CORP.
  7. Lower the vehicle.
  8. Connect the negative battery cable. Tighten:  Tighten the battery terminal bolts to 17 N.m (13 lb ft).
  9. Reset the clock to preset the radio stations.
scientia non olet · About LEMON Manuals