LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2004 >> L300 4D Sedan, 2.2 F >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.2L (L61) (Introduction) >> Repair Instructions >> Ignition Control Module Replacement >> Installation Procedure

Installation Procedure

NOTE: Refer to Fastener Notice in Cautions and Notices.
IMPORTANT: Make sure the interconnect is lined up and the interconnect seal is in place before installing the attachment screws.
  1. Install the EI module and the attachment screws. Tighten:  Tighten the EI module screws to 1.5 N.m (13 lb in).
  2. Connect the module harness connector. Push in the connector until a click is heard, then pull back to confirm a positive engagement.
    3. Fig 1: Removing & Installing Ignition Control Module
    GM896789Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals