LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2004 >> L300 4D Sedan, 2.2 F >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.2L (L61) (Introduction) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

    NOTE: To facilitate installation of the tank pressure sensor into its mounting boss on the fuel pump module cover, lightly lubricate the multi-ribbed seal on the tank pressure sensor. A drop of clean engine oil is sufficient.
  1. Install the tank pressure sensor into the fuel pump module cover mounting boss.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the retaining nut and washer. Tighten:  Tighten the FTP sensor nut to 2 N.m (18 lb in).
  3. Install the electrical connector to the FTP sensor.
  4. Install the fuel tank. Refer to Fuel Tank Replacement .
    5. Fig 1: Removing & Installing Fuel Tank Pressure Sensor
    GM892357Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals