LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2004 >> L300 4D Sedan, 2.2 F >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.2L (L61) (Introduction) >> Repair Instructions >> Accelerator Controls Cable Bracket Replacement >> Installation Procedure

Installation Procedure

  1. Install the accelerator cable bracket to the throttle body.
    2. Fig 1: Removing & Installing Accelerator Cable Bracket
    GM12689Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts and bolts.
    1. Tighten: 
      • Tighten the bolts to 10 N.m (89 lb in).
      • Tighten the nut to 13 N.m (115 lb in).
  3. Connect the accelerator cable into the accelerator cable bracket.
  4. Connect the accelerator cable cross slug to the throttle body slots.
    5. Fig 2: Removing & Installing Accelerator & Cruise Control Cables From Accelerator Cable Bracket
    GM294522Courtesy of GENERAL MOTORS CORP.
  5. If applicable connect the cruise control cable to the throttle lever and accelerator bracket.
    6. Fig 3: Identifying Cruise Control Cable
    GM319387Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals