LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2004 >> Ion Red Line >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Ignition Switch Replacement >> Installation Procedure

Installation Procedure

    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the ignition switch and screws on to the steering column.

    Tighten:  Tighten the screws to 2 N.m (17 lb in).

  2. Connect the ignition switch harness connector.
    3. Fig 1: View Of Ignition Switch
    GM854768Courtesy of GENERAL MOTORS CORP.
  3. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
    IMPORTANT: If the ignition switch is replaced and a learn procedure is not performed, the engine will crank but not start or will start and stall immediately.
  4. Perform the vehicle theft deterrent system learn procedure. Refer toProgramming Theft Deterrent System Components in Theft Deterrent.
scientia non olet · About LEMON Manuals