LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2004 >> Ion Red Line >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Ignition Lock Cylinder Case Replacement >> Installation Procedure

Installation Procedure

  1. Install the ignition lock cylinder into the lock cylinder housing. Refer to Ignition Lock Cylinder Replacement .
  2. Install the lock cylinder case housing to the steering column.
  3. Install the lock cylinder case housing clamp and new shear bolts.
    4. Fig 1: View Of Ignition Lock Cylinder Case
    GM854922Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Rock the lock cylinder case back and forth to ensure it is seated into the lock bolt cutout. Tighten the shear bolts evenly.
  4. Tighten the shear bolts until the heads break off.
    5. Fig 2: View Of Lock Cylinder Case Housing Clamp
    GM854916Courtesy of GENERAL MOTORS CORP.
  5. If applicable, connect the ignition lock cylinder solenoid harness connector.
  6. Connect the ignition switch harness connector to the lock module.
    7. Fig 3: View Of Ignition Switch Harness Connector
    GM854934Courtesy of GENERAL MOTORS CORP.
  7. Install the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement in SIR.
    8. Fig 4: View Of Inflatable Restraint Steering Wheel Module
    GM854958Courtesy of GENERAL MOTORS CORP.
  8. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  9. Install the steering wheel. Refer to Steering Wheel Replacement .
scientia non olet · About LEMON Manuals