Enabling Procedure
- Remove the key from the ignition switch.
- Connect the I/P module connector (1) to the vehicle harness connector (2).
- Install the CPA to the I/P module connector (2).
- Install the right outer trim cover to the I/P (3). Refer to Instrument Panel (I/P) Trim Panel Replacement - Right in Instrument Panel, Gages and Console.
- Install the AIR BAG fuse into the body control module fuse center.
- Install the body control module fuse center cover.
- Use caution while reaching in and turn the ignition switch to the ON position.
The AIR BAG indicator will flash then turn OFF.
- Perform the SIR Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - SIR .