LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2004 >> Ion Red Line >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Inflatable Restraint Side Impact Sensor Replacement (Sedan) >> Installation Procedure

Installation Procedure

  1. Remove any dirt, grease, or other impurities from the mounting surface.
  2. Install the SIS to the center pillar by sliding the sensor fasteners into the keyhole in the sheet metal.
    3. NOTE: Refer toFastener Notice in Cautions and Notices.
  3. Install the SIS mounting fasteners.

    Tighten:  Tighten the fasteners to 7.5 N.m (66 lb in).

  4. Install the harness connector to the SIS.
  5. Install the CPA to the SIS harness connector.
    6. Fig 1: View Of Inflatable Restraint Side Impact Sensor
    GM876618Courtesy of GENERAL MOTORS CORP.
  6. Install the lower trim panel to the center pillar. Refer to Garnish Molding Replacement - Center Pillar Lower in Interior Trim.
  7. Move the seat to the original position.
  8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 (Coupe)  or SIR Disabling and Enabling Zone 2 (Sedan)  or to SIR Disabling and Enabling Zone 6 (Coupe)  or SIR Disabling and Enabling Zone 6 (Sedan) .
scientia non olet · About LEMON Manuals