LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2004 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Exhaust System) >> Repair Instructions >> Wheel Drive Shaft Heat Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Ion Red Line, 2005 Saturn Ion 3, 2005 Saturn Ion 2, and 2005 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wheel drive shaft heat shield into position on the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the wheel drive shaft heat shield-to-engine block bolt.

    Tighten:  Tighten the bolt to 30 N.m (22 lb ft).

    3. Fig 1: View Of Wheel Drive Shaft Heat Shield
    GM878832Courtesy of GENERAL MOTORS CORP.
  3. Install the wheel drive shaft heat shield-to-transmission mount bracket bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals