LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2004 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Exhaust System) >> Repair Instructions >> Exhaust Heat Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Ion Red Line, 2005 Saturn Ion 3, 2005 Saturn Ion 2, and 2005 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the exhaust heat shield into position on the vehicle.
  2. Install new heat shield retaining rivets.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the exhaust heat shield retaining nut.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

    4. Fig 1: View Of Exhaust Heat Shield
    GM878833Courtesy of GENERAL MOTORS CORP.
  4. Remove the support from the exhaust extension pipe.
  5. Install the exhaust extension pipe forward insulators to the underbody hangers.
  6. Install the catalytic converter pipe to the vehicle. Refer to Catalytic Converter Replacement (L61)  or Catalytic Converter Replacement (LSJ) .
  7. Install the post catalytic converter HO2S wiring (1).
    8. Fig 2: Locating HO2S Electrical Harness
    GM889722Courtesy of GENERAL MOTORS CORP.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals