Engine Flywheel Installation

WARNING: This page is about a different car, the 2004 Saturn Ion 3, 2004 Saturn Ion 2, and 2004 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 38122-A Crankshaft Balancer Holder
J 45059 (SA9140E) Angle Meter

Install the flywheel.
Install the new bolts.

Fig 1: View Of Flywheel

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Holding the crankshaft damper with the J 38122-A , tighten the bolts evenly.
Tighten: Using the J 45059 (SA9140E), tighten the bolts to 53 N.m (39 lb ft), plus 25 degrees.