Installation Procedure
- Position the wiper motor to the wiper drive system module.
- Install the wiper motor screws.
Tighten: Tighten the screws to 8 N.m (71 lb in).
- Install the wiper motor crank arm and crank arm nut.
Tighten: Tighten the screws to 25 N.m (18 lb ft).
- Install the wiper drive system module. Refer toWiper Drive System Module Replacement .
- Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
NOTE:
Refer toFastener Notice
in Cautions and Notices.