LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2003 >> Vue 3.0 B, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Body Control System >> Diagnostic Information and Procedures >> DTC B1001: Module Is Not Configured Properly >> Test Description

Test Description

The number below refers to the step number on the diagnostic table.

  1. 3:  If DTC B1001 is set as current, reprogram the module.
DTC B1001

Step Action Yes No
Connector End View Reference: Master Electrical Component List in Wiring Systems
1 Did you perform the Diagnostic System Check for the system exhibiting the symptom? Go to Step 2  Go to Control Module References  for the applicable Diagnostic System Check
2
  1. Install the scan tool.
  2. Turn On the ignition with the engine Off.
  3. Retrieve the DTCs.
Is the DTC retrieved as current?		 Go to Step 3  Go to Diagnostic Aids
3  Perform the programming or set up procedure for the module. Refer to Control Module References  for the proper procedure.
Does the DTC reset?		 Go to Step 4  System OK
4
IMPORTANT: Perform the programming or set up procedure for the replaced control module.
Replace the module. Refer to Control Module References  for applicable replacement procedure.Did you complete the replacement?		 System OK -
scientia non olet · About LEMON Manuals