LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2003 >> LW200 >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing Steering Wheel With Attachment Nut
    GM862539Courtesy of GENERAL MOTORS CORP.
  1. Remove the yellow tab or tape from the SIR coil assembly.
  2. Route the wiring through the steering wheel and install the steering wheel onto the steering shaft noting the orientation notch that locates the steering wheel in the correct position.
    3. NOTE: Refer to FASTENER NOTIC in Cautions and Notices.
    IMPORTANT: A new steering wheel attachment nut must be used.
  3. Install a NEW steering wheel attachment nut.

    Tighten:  Tighten the steering wheel nut to 40 N.m (30 lb ft).

    4. Fig 2: Locating Steering Wheel Electrical Connectors
    GM862526Courtesy of GENERAL MOTORS CORP.
  4. If equipped, connect the cruise control and switch connectors. Attach the harness to the wheel.
  5. Install the SIR inflator module. Refer to REMOVAL & INSTALLATION (DRIVER-SIDE) in Air Bag Restraint Systems.
  6. Connect the inflator module wiring harness and the horn lead. Be sure to install the connector position assurance (CPA) device.
  7. Align the inflator module to the steering wheel and press to install.

    Be sure to seat all 4 attachment points.

  8. Enable the SIR system. Refer to DISABLING SYSTEM or ACTIVATING SYSTEM in Air Bag Restraint Systems.
scientia non olet · About LEMON Manuals