Transaxle Case Disassemble

Tools Required

• 87-90-800  Drift, Differential Seal. See Special Tools and Equipment .
• 87-91-311  Bearing Driver Shaft Sleeve. See Special Tools and Equipment .
• 87-92-236  Support. See Special Tools and Equipment .

Fig 1: View Of Input Shaft Bearing Retainer
Courtesy of GENERAL MOTORS CORP.
1. Remove the input shaft bearing retainer screws and the retainer.
Fig 2: Removing Input Shaft Bearing Race
Courtesy of GENERAL MOTORS CORP.
2. Press out the input shaft bearing race using the 87-90-800  . See Special Tools and Equipment . Use the 87-92-236  as a base for the pressing operation. See Special Tools and Equipment .
Fig 3: Removing Output Shaft Bearing Race
Courtesy of GENERAL MOTORS CORP.
3. Press out the output shaft bearing race using the 87-91-311  . See Special Tools and Equipment .
Fig 4: Removing Transaxle Vent Filter
Courtesy of GENERAL MOTORS CORP.
4. Remove the transaxle vent filter from the case using a punch. Drive the vent from the outside to the inside.