LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2003 >> L200 Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transaxle >> Repair Instructions >> Shift Control Shaft Lever Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing Control Shaft Lever To Shift Control Shaft Retaining Pin
    GM895346Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When installing the control shaft lever assembly, guide the shifter rod and transaxle shift fork block in place before installing the retaining clips.
  1. Install the control shaft lever assembly into the vehicle and install the retaining clips.
  2. Install the retaining pin that retains the control shaft lever to shift control shaft of transaxle.
    3. Fig 2: Locating Control Assembly Rod Pinch Bolt
    GM895332Courtesy of GENERAL MOTORS CORP.
  3. Tighten the pinch bolt securing the control assembly rod to control shaft lever assembly.

    Tighten:  Tighten the control assembly rod-to-control lever assembly pinch bolt to 12 N.m (9 lb ft) + 180°.

    4. Fig 3: View Of Spring Loaded Locking Pin/Hole Plug
    GM895339Courtesy of GENERAL MOTORS CORP.
  4. Release the transaxle shift control shaft.
    • If the transaxle has a spring loaded locking pin, remove the punch from the shift lever and rock the lever back and forth until the lever can be moved freely.
      • IMPORTANT: If the transaxle hole plug was damaged during removal, install a new plug during assembly.
    • If there was a plug in the transaxle hole, remove the punch from the shift lever, remove the 87-92-335  , and install the plug. See Special Tools and Equipment .
    5. Fig 4: Removing Power Steering Line Hose Clip
    GM893366Courtesy of GENERAL MOTORS CORP.
  5. Install the hose clip to the 2 power steering lines.
  6. Pull the AIR tube back to the original position.
    7. Fig 5: Installing AIR Tube To AIR Hose
    GM893363Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The clamp must be installed with the locking portion facing down.
  7. Insert the tube into the hose and install the clamp.
    8. Fig 6: Removing Power Steering Line Hose Clip
    GM893366Courtesy of GENERAL MOTORS CORP.
    NOTE: There is a stand-off clip between the AIR tube and the wiring harness at the front of the transaxle. This must be in place to eliminate the possibility of chafing between the tube and the harness.
  8. Ensure the stand-off clip between the AIR tube and the wiring harness is installed correctly.
  9. Install the console. Refer to CONSOLE REPLACEMENT in Instrument Panel, Gages & Console.
    10. Fig 7: Removing & Installing Shifter Boot - 5-Speed Transaxles
    GM895322Courtesy of GENERAL MOTORS CORP.
  10. Snap the control lever boot into the console opening.
scientia non olet · About LEMON Manuals