Engine Compression Test

Perform the following steps in order to conduct a compression test for the L61.

1. Conduct the following steps in order to check cylinder compression.
   1. Engine should be at room temperature.
   2. Disconnect wiring from the ignition module.
   3. Remove the spark plugs.
   4. Throttle body valve should be wide open.
   5. Battery should be at or near full charge.
2. For each cylinder, crank engine through four compression strokes.
3. The lowest reading cylinder should not be less than 70% of the highest.
4. No cylinder reading should be less than 689 kPa (100 psi).

• Normal - Compression builds up quickly and evenly to specified compression on each cylinder.
• Piston Rings - Compression low on first stroke. Tends to build up on following strokes but does not reach normal. Improves considerably with addition of oil.
• Valves - Compression low on first stroke. Does not tend to build up on the following strokes. Does not improve much with the addition of oil. Use approximately three squirts from a plunger-type oiler.