LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2003 >> L200 Automatic >> Repair and Diagnosis (Single Page) >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Repair Instructions >> Sunroof Module Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing & Installing Sunroof Module Assembly
    GM861206Courtesy of GENERAL MOTORS CORP.
  1. With an assistant, position the sunroof module into the studs located on the roof ring.
  2. Install the 2 center bolts which secure the sunroof module to the roof and tighten the bolts by hand.
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the remaining sunroof module bolts.

    Tighten:  Tighten all of the bolts to 10 N.m (89 lb in).

    4. Fig 2: Connecting Front And Rear Drain Hoses To Drain Spigots
    GM893482Courtesy of GENERAL MOTORS CORP.
  4. Connect the front and rear drain hoses to the drain spouts on the sunroof module.
    5. Fig 3: Connecting Sunroof Module Electrical Connector
    GM861204Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connectors to the sunroof motor/actuator.
  6. Secure the harness to the sunroof module.
  7. Adjust the sunroof window. Refer to Sunroof Window Height and Opening Fit Adjustment .
  8. Cycle the sunroof to verify proper operation before securing the headliner.
  9. Install the headliner. Refer to Headliner Replacement (Wagon) or Headliner Replacement (Sedan) in Interior Trim.
scientia non olet · About LEMON Manuals