LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> Vue 2.2 D, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1635 (Cruise Control System) >> Repair Instructions >> Cruise Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Ion 3, 2003 Saturn Ion 2, and 2003 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the cruise control module to the mounting bracket.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    Fig 1: Locating Cruise Control Cable
    GM854297Courtesy of GENERAL MOTORS CORP.
  2. Install the cruse control module to bracket nuts (2).

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  3. Connect the cruise control cable to the accelerator pedal.
    4. Fig 2: Identifying Twisted Ribbon
    GM293672Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The ribbon must not be twisted.
  4. Connect the cruise control cable (2) to the cruise control module ribbon (4).
    5. Fig 3: Connecting Cruise Control Cable To Module Ribbon
    GM325857Courtesy of GENERAL MOTORS CORP.
  5. Insert the cruise control cable into the cruise control module until the seal touches the module.
    6. Fig 4: Aligning Cruise Control Cable
    GM329483Courtesy of GENERAL MOTORS CORP.
  6. Position the narrow cable tab into the narrow slot and the wide tab into the wide slot.
    7. IMPORTANT: The adjuster tab must be pointing toward the front of the car after installation.
  7. Connect the cruise control cable to the cruise control module by turning the cable clockwise.
  8. Connect the cruise control module harness connector.
  9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Battery.
scientia non olet · About LEMON Manuals