Cruise Release Switch: Installation
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When installing the brake pedal switches, it is very important that the brake pedal remain in the full up or at rest position, or damage to the brake system and or switch misadjustment may occur.
- Connect the electrical connector to the switch.
- Install the cruise control release switch (5) into the opening in the bracket (1).
- Turn the switch clockwise until the switch connector is at the 6 o'clock position.
- Adjust the switch. See CRUISE RELEASE SWITCH under ADJUSTMENTS.
- Install the left insulator panel.
NOTE:
The release switch assembly and the brakelight switch assembly cannot be adjusted until after the brake booster pushrod is assembled to brake pedal assembly. Incorrect adjustment could cause the cruise control system to not work properly.