Component Resistance

Connect DVOM between specified terminals at component or at transaxle 20-pin connector to transaxle. See Figure . Measure individual component resistance at specified temperature. See COMPONENT RESISTANCE SPECIFICATIONS table. If resistance is not as specified, replace appropriate component. See Figure .

COMPONENT RESISTANCE SPECIFICATIONS

Component

Pins ⁽¹⁾

Ohms ⁽²⁾

Ohms ⁽³⁾

Resistance To Ground (Case)

Pressure Control Solenoid

C & D

3-5

4-7

⁽⁴⁾

Input Speed Sensor

S & V

615-700

750-835

⁽⁵⁾

Output Speed Sensor

A & B ⁽⁶⁾

1530-1650

1700-1870

⁽⁵⁾

TCC Solenoid

T & E

10-11

13-15

⁽⁴⁾

TFT Sensor ⁽⁷⁾

L & M

3106-3923

164-190

⁽⁸⁾

1-2 Shift Solenoid

A & E

19-24

24-31

⁽⁴⁾

2-3 Shift Solenoid

B & E

19-24

24-31

⁽⁴⁾

⁽¹⁾	Resistance is measured between specified terminals at component or at transaxle 20-pin connector. See Figure .

⁽²⁾	Resistance is measured at 68°F (20°C).

⁽³⁾	Resistance is measured at 212°F (100°C).

⁽⁴⁾	Greater than 250 k/ohms.

⁽⁵⁾	Greater than 10 megohms.

⁽⁶⁾	Resistance is measured at speed sensor.

⁽⁷⁾	The resistance of this device is necessarily temperature dependent, and will therefore vary far more than any other device. See TEMPERATURE SENSOR RESISTANCE table under DESCRIPTION & OPERATION.

⁽⁸⁾	Greater than 20 megohms.