LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> LW200 Automatic >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Ignition Lock Cylinder Case Replacement >> Removal Procedure

Removal Procedure

  1. Remove the steering wheel. Refer to Steering Wheel Replacement .
  2. Remove the steering column trim covers. Refer to Steering Column Trim Cover Replacement .
  3. Remove the inflatable restraint steering wheel module coil. Refer to SIR COIL ASSEMBLY .
    4. Fig 1: Removing & Installing Multifunction Switch Housing
    GM891592Courtesy of GENERAL MOTORS CORP.
  4. Remove the multifunction switch housing. Refer to Multifunction Turn Signal Switch Housing Replacement 
    5. Fig 2: View Of Ignition Switch Harness Connector
    GM854934Courtesy of GENERAL MOTORS CORP.
  5. If applicable, disconnect the ignition lock cylinder solenoid harness connector.
  6. Disconnect the ignition switch harness connector.
    7. Fig 3: View Of Chiseling Into Shear Bolt
    GM854925Courtesy of GENERAL MOTORS CORP.
  7. Using the following procedure, remove the ignition lock cylinder case shear bolts:

    7.1. Use a hammer and chisel to bite into the shear bolt at a position offset from center.

    7.2. Tap the chisel to rotate the bolt in order to loosen it. Repeat as necessary until bolt is loose enough to remove.

    8. Fig 4: Removing & Installing Ignition Lock Cylinder Case Housing
    GM891608Courtesy of GENERAL MOTORS CORP.
  8. Remove the ignition lock cylinder case housing from the steering column.
  9. Remove the ignition lock cylinder from the lock cylinder case housing. Refer to Ignition Lock Cylinder Replacement .
scientia non olet · About LEMON Manuals