LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> LW200 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 304 (Wheel Alignment) >> Repair Instructions >> Front Camber Adjustment >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2003 Saturn LW300, 2003 Saturn LW200, 2003 Saturn L300, and 2003 Saturn L200. However, it is still accessible from the selected car via links, so may be relevant.

SA9140E  Torque Angle Gage

IMPORTANT: Rear wheel alignment angles must be set to correct specifications before front wheel alignment angles are adjusted.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the wheel and tire assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
    3. Fig 1: Removing & Installing Strut-To-Steering Knuckle Nuts & Bolts
    GM891540Courtesy of GENERAL MOTORS CORP.
  3. Remove the strut to knuckle nuts and bolts. Discard the nuts and bolts.
    4. Fig 2: Modifying Front Strut For Camber Angle Adjustment
    GM861569Courtesy of GENERAL MOTORS CORP.
  4. If the strut has not been previously modified, perform the following procedure:
    1. Disconnect the strut from the knuckle.
      2. IMPORTANT:
      • The strut mounting bracket consists of two layers of metal, file the inner layer no further than the slot in the outer layer.
      • If filing the strut, paint the exposed metal with primer.
    2. If increasing negative camber, remove the material from the outside of the lower strut hole.
    3. If decreasing negative camber, remove the material from the inside of the lower strut hole.
    5. Fig 3: Removing & Installing Strut-To-Steering Knuckle Nuts & Bolts
    GM891540Courtesy of GENERAL MOTORS CORP.
  5. Loosely install the new strut to knuckle nuts and bolts.
    6. Fig 4: Performing Camber Angle Adjustment
    GM891542Courtesy of GENERAL MOTORS CORP.
  6. Adjust the camber to specifications by moving the top of the wheel in or out as necessary. Refer to Wheel Alignment Specifications .
    7. NOTE: Refer to FASTENER NOTIC in Cautions and Notices.
  7. Using the SA9140E  , tighten the strut to knuckle nuts and bolts.

    Tighten: 

    1. Tighten the nuts and bolts to 50 N.m (37 lb ft).
    2. Tighten the nuts and bolts to 100 N.m (74 lb ft) plus an additional 30 to 45 degrees.

  8. Install the wheel and tire assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  9. Lower the vehicle.
  10. Check the camber angles and adjust as necessary.
scientia non olet · About LEMON Manuals