LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> LW200 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 275 (Cruise Control System) >> Repair Instructions >> Cruise Release Switch Adjustment

Cruise Release Switch Adjustment

WARNING: This page is about a different car, the 2003 Saturn LW300, 2003 Saturn LW200, 2003 Saturn L300, and 2003 Saturn L200. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing & Installing Driver-Side Lower Dash Closeout Panel & Lower Air Duct
    GM888497Courtesy of GENERAL MOTORS CORP.
  1. Remove left side lower instrument panel (I/P) closeout panel (hush panel) push pin fasteners and remove panel.
  2. Remove left side lower heater duct assembly push pin fastener and remove duct.
    3. Fig 2: Installing Cruise Brake Switch
    GM893285Courtesy of GENERAL MOTORS CORP.
  3. Remove cruise brake switch by rotating it 180 degrees so it will pull out from the bracket.
  4. Pull switch plunger all the way out, which may require moderate force.
    5. IMPORTANT: The notch on plunger will be fully visible when plunger is all the way out.
  5. Install cruise brake switch into bracket and rotate 180 degrees while holding brake pedal down during installation.
  6. Adjust cruise brake switch by pulling brake pedal all the way up by hand. The switch internal ratchet mechanism will lock switch in the adjusted position.
  7. Install left side lower heater duct and push pin fastener.
  8. Install left side lower I/P closeout panel (hush panel) and push pin fasteners.
scientia non olet · About LEMON Manuals