LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> LW200 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 266 (HVAC Systems - Automatic) >> Repair Instructions >> Blower Motor Control Processor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn LW300, 2003 Saturn LW200, 2003 Saturn L300, and 2003 Saturn L200. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE in Battery.
  2. Remove the instrument panel storage compartment. Refer to Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages and Console.
    3. Fig 1: Removing/Installing Right Side Heater Duct Assembly & Retainer
    GM896489Courtesy of GENERAL MOTORS CORP.
  3. Remove the heater outlet retainer.
  4. Remove the heater outlet.
    5. Fig 2: Locating Recirculation Actuator Electrical Connector
    GM894265Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the recirculation actuator electrical connector.
  6. Disconnect the aspirator hose and position the hose aside.
    7. Fig 3: Removing & Installing Blower Motor Control Module
    GM1242398Courtesy of GENERAL MOTORS CORP.
  7. Remove the blower motor resistor screws.
  8. Use the electrical harness to pull the blower motor control module out of the HVAC module.
  9. Disconnect the blower motor control module electrical connector.
scientia non olet · About LEMON Manuals