LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2002 >> L200 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place a new stud in the wheel hub.
    2. Fig 1: Installing Wheel Stud
    GM65317Courtesy of GENERAL MOTORS CORP.
  2. Place some washers (1) onto the wheel stud (3).
    3. IMPORTANT: Make sure that the wheel stud is fully seated against the wheel hub flange.
  3. With the flat side of a wheel nut against the washers, tighten the wheel nut until the wheel stud head seats against the wheel hub flange.
  4. Remove the wheel nut and washers.
  5. Install the rear wheel hub/speed sensor assembly into the suspension knuckle. Refer to Wheel Bearing/Hub Replacement - Rear .
  6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals