Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Install the stabilizer shaft to the vehicle.
- Install the stabilizer shaft insulator clamps to the stabilizer shaft and the crossmember.
Tighten:
- Tighten the stabilizer shaft insulator clamp bolts to 65 N.m (49 lb ft).
- Tighten the stabilizer shaft insulator clamp nuts to 95 N.m (70 lb ft).
- Install the stabilizer shaft links to the stabilizer shaft.
Tighten: Tighten the stabilizer shaft link nuts to 72 N.m (53 lb ft).
- Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle.
NOTE:
Refer to Fastener Notice in Cautions and Notices.