LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2000 >> SC1 Standard >> Repair and Diagnosis >> Transmission >> Manual Transmission Clutches >> Manual Transaxle Removal And Installation >> Console >> Installation

Manual Transaxle Removal And Installation: Console: Installation

  1. Apply park brake.
  2. Adjust front seats to most rearward position.
  3. Recline driver's and passenger's seat backs as far down as possible.
  4. Select neutral for transaxle gear (on automatic transaxles).
  5. Hold front end of console down and rear end up.
  6. Position all harnesses so they can be accessed.
  7. Maneuver console over gear selector lever and past brake lever.
    Fig 1: Installing Console
    G01033331Courtesy of GENERAL MOTORS CORP.
  8. Connect power outlet electrical connector.
    Fig 2: Power Outlet Connector
    G01033332Courtesy of GENERAL MOTORS CORP.
  9. Install rear console screws and tighten.

    Torque Rear Console Screw: 2.5 N.m (22 in-lbs) 

    Fig 3: Rear Console Screws.
    G01033333Courtesy of GENERAL MOTORS CORP.
  10. Install front console screws and tighten.

    Torque Front Console Screw: 2.5 N.m (22 in-lbs) 

  11. Install left and right extension panels by inserting hinges into console.
  12. Rotate close and push in at dual lock locations.
    Fig 4: Install Left And Right Extension Panels
    G01033334Courtesy of GENERAL MOTORS CORP.
  13. Connect window switch assembly connectors (if equipped).
  14. Install window switch assembly or storage tray (depending on equipment).
    Fig 5: Window Switch Assembly
    G01033335Courtesy of GENERAL MOTORS CORP.
  15. Enable SIR system.
scientia non olet · About LEMON Manuals