LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2000 >> LS Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Air Bag Restraint Systems) >> Disabling & Activating Air Bag System >> Disabling System

Disabling System

WARNING: This page is about a different car, the 2001 Saturn LW300, 2001 Saturn LW200, 2001 Saturn L300, 2001 Saturn L200, and 2001 Saturn L100. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When AIR BAG fuse is removed and ignition switch is in RUN position, AIR BAG warning light will be on. This does not indicate a system malfunction.
  1. Turn steering wheel to place vehicle wheels in straight-ahead position. Turn ignition switch to LOCK position.
  2. Remove IGN1 fuse (10-amp) from under hood fuse block. Remove driver-side knee bolster (steering column filler). Remove Connector Position Assurance (CPA) clips and disconnect driver and passenger-side Yellow 2-pin connectors at base of steering column. See Fig 1.
  3. On models equipped with head impact air bags, remove upper seat belt shoulder bolt from left and right rear seat belts. Fold down rear seat. Remove upper quarter panel trim assembly from driver and passenger-side C-pillars. Remove Connector Position Assurance (CPA) clips and disconnect driver and passenger-side Yellow 2-pin connectors for head impact air bag modules. See Fig 2.
Fig 1: Identifying Driver & Passenger-side Air Bag Yellow 2-pin Connectors
G99E00319Courtesy of GENERAL MOTORS CORP.
Fig 2: Identifying Side Impact Air Bag Yellow 2-pin Connector (Sedan Shown; Wagon Is Similar)
G99A23382Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals