LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2011 >> 9-5 Turbo4, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Basic Engine, V6) >> Adjustment Replacement >> Engine Mount Inspection

Engine Mount Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Install the engine support fixture engine bridge, retainer frame. Refer to ENGINE SUPPORT FIXTURE (REAR LEFT SIDE)  or ENGINE SUPPORT FIXTURE (REAR RIGHT SIDE) .
  2. Observe the engine mount while raising the engine. Raising the engine removes the weight from the engine mount and creates slight tension on the rubber.
  3. Replace the engine mount if the engine mount exhibits any of the following conditions:
    • The hard rubber is covered with heat check cracks.
    • The rubber is separated from the metal plate of the engine mount.
    • The rubber is split through the center of the engine mount.
  4. For engine mount replacement, refer to one of the following:
scientia non olet · About LEMON Manuals