To remove

Before removing the control module to change it, perform PROCEDURES BEFORE DISMANTLING THE CONTROL MODULE .

1. Detach the engine's wiring harness from the coolant hose.
   IMPORTANT: Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves straight apart to avoid bending the pins. For further information regarding connectors, refer to CONNECTORS, HANDLING AND INSPECTION .
2. Pull out the lock pin, press down the lock and unplug the control module connector.
   Fig 1: Locating Control Module Connector

   Courtesy of SAAB-SCANIA OF AMERICA, INC.
3. Put the gear selector in position P and undo the nut to the lever. Engage position N before removing the lever.
   Fig 2: Illustration For Steps 3 - 6

   Courtesy of SAAB-SCANIA OF AMERICA, INC.
4. Remove the lever. Pull back the gear cable and lift it up.
5. Remove the bolts securing the control module.
6. Lift the control module off the shaft and connector. Lift straight up to avoid damaging the connector on the gearbox.