LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2010 >> 9-5 >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Theft Protection >> Fault diagnosis, fault codes >> DTC B389A: Incorrect Location Identifier >> Circuit/System Verification

Circuit/System Verification

  1. Check that B389A has not been set in conjunction with BCM replacement or programming.

    ==> If the DTC was set in conjunction with BCM replacement or programming, this indicates that the immobilizer programming process has not been completed. See Immobilizer System, Component Programming .

  2. Check that DTC B3902 has not been set in any of the following control modules:
    • ECM
    • SDM
    • EBCM
    • HVAC
    • ESCL
    • IPC

    ==> If DTC B3902 is set in any of these control modules, see DTC B3902 .

  3. Delete all DTCs and operate the steering column lock control module within the conditions indicated by the DTC. The DTC must not be set.

    ==> If the DTC is set, replace control module K9 BCM.

scientia non olet · About LEMON Manuals