Window Motor Relearn Procedure

A relearn procedure may need to be performed for any LIN window motor for the following conditions:

When the window glass is out of alignment
When the window glass has been replaced
When the door has been replaced
When the window regulator has been replaced

NOTE: Prior to performing the relearn procedure the vehicle must have all 4 wheels properly inflated and mounted, the vehicle must be sitting on a level surface and all doors must be completely closed.

To relearn the window motor, follow these steps:

Ignition ON.
With a scan tool, select Module Diagnosis, Body Control Module, Configuration/Reset Functions and then select the appropriate Clear Window Learn Values for the window motor requiring the relearn procedure.
Terminate the programming routine on the scan tool once programming is complete. The window lift can not be normalized and will not operate until the program has been terminated.
Initially, the window should be completely closed. Press and hold the power window switch until the window is fully open and continue holding the switch down for approximately 5 seconds after the window is completely open.
Pull the power window switch up until the window is fully closed and continue holding the switch up for approximately 5 seconds after the window is completely closed.

The window is now reprogrammed.