LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2010 >> 9-5 >> Repair and Diagnosis (Single Page) >> Engine Performance >> Testing & Diagnosis >> Engine Management And Fuel System, V6 (2 Of 5) >> DTC P025A: Fuel Pump Control Module Enable Circuit >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the K27 fuel pump control module.
  2. Ignition OFF, connect a test lamp between the control circuit terminal 13 and ground.
  3. Ignition ON, command the fuel pump ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
  4. If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K20 ECM.
  5. If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K20 ECM.
  6. If all circuits test normal, replace the K27 fuel pump control module.
scientia non olet · About LEMON Manuals