LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2010 >> 9-5 >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Driver Information, Main Instrument Unit And SID >> Fault diagnosis, fault codes >> DTC B3567: Info Display Select Switch Circuit >> Component Testing >> Static Test

Static Test

  1. Ignition OFF, disconnect the harness connector at the S78 Turn Signal/Multi-Function Switch.
  2. Test for 8.5-9.1 kΩ between the signal terminal 12 and the low reference circuit terminal 6.
  3. If not within the specified range, replace the S78 Turn Signal/Multi-Function Switch.
  4. Test for 550-650 Ω between the signal terminal 12 and the low reference circuit terminal 6 while pressing the Up switch.
  5. If not within the specified range, replace the S78 Turn Signal/Multi-Function Switch.
  6. Test for 1.5-1.7 kΩ between the signal terminal 12 and the low reference circuit terminal 6 while pressing the Down switch.
  7. If not within the specified range, replace the S78 Turn Signal/Multi-Function Switch.
  8. Test for 3.3-3.7 kΩ between the signal terminal 12 and the low reference circuit terminal 6 while pressing the Reset switch.
  9. If not within the specified range, replace the S78 Turn Signal/Multi-Function Switch.
  10. Test for less than 5 Ω between the signal terminal 5 and the low reference circuit terminal 6 while pressing the Menu switch.
  11. If greater than the specified value, replace the S78 Turn Signal/Multi-Function Switch.
scientia non olet · About LEMON Manuals