LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2010 >> 9-5 >> Repair and Diagnosis (Single Page) >> Electrical >> Component Locations >> OEM Wiring Harness And Component Locations >> Fault diagnosis, fault codes >> DTC B1370: Control Module Ignition On and Start Circuit; DTC B1380: Control Module Ignition Accessory Circuit; DTC B1441: Control Module Ignition Off, Run, and Start Circuit >> Component Testing >> Ignition Switch

Ignition Switch

  1. Ignition OFF, disconnect the harness connector at the S39 ignition switch.
  2. Verify the resistance between the terminals listed below match for each S39 ignition switch position.
  3. If not the specified value, replace the S39 ignition switch.
scientia non olet · About LEMON Manuals