| Operating Conditions:
Ignition ON |
| In Park Switch Status |
On/Off |
The scan tool displays Off or On. On is displayed if the vehicle was in Park during the last open or close history data. |
| Liftgate Ajar Switch |
Active/Inactive |
The scan tool displays Active or Inactive Closed. Active is displayed if the liftgate is open. This was the last state of the liftgate ajar switch in the open or close history data. |
| Liftgate Angle |
0° |
The scan tool displays the calculated angle in degrees of the liftgate relative to the liftgate latch. |
| Liftgate Disable Switch |
Quantity |
The scan tool displays the number of times the switch has been disabled. |
| Liftgate Front Control Switch |
Active/Inactive |
The scan tool displays Active or Inactive. This is the state of the front control switch of the liftgate module. |
| Liftgate Handle Switch |
Active/Inactive |
The scan tool displays Active or Inactive. This is the state of the liftgate handle switch. |
| Liftgate Latch Pawl Switch |
Active/Inactive |
The scan tool displays Active or Inactive. This is the state of the latch pawl switch. |
| Liftgate Latch Pawl Switch |
Active/Inactive |
The scan tool displays Active or Inactive. This is the state of the latch pawl switch. |
| Liftgate Latch Sector Switch |
Active/Inactive |
The scan tool displays Active or Inactive. This is the state of the latch sector switch. |
| Liftgate System Voltage 1 |
11.5-13.0 V |
The scan tool displays the battery system 1 voltage input to the liftgate module. |
| Liftgate System Voltage 2 |
11.5-13.0 V |
The scan tool displays the battery system 2 voltage input to the liftgate module. |
| Rear Liftgate Switch |
Active/Inactive |
The scan tool displays Active or Inactive. This is the state of the liftgate shutface switch. |
| Secondary Obstacle Detection Voltage |
4.5-5.0 V |
The diagnostic tool shows the present voltage in the tailgate's obstruction sensor. The voltage is measured by the tailgate module. |