Specifications Index
9-5 SPECIFICATIONS INDEX
| System | Specification/Procedure | |
|---|---|---|
| Air Conditioning | ||
| Service | SPECIFICATIONS | |
| Torque | TIGHTENING TORQUES | |
| Axle Shaft Hub Nut | 170 Ft. Lbs. (230 Nm). Use New Nut. | |
| Battery | SPECIFICATION | |
| Brakes | ||
| Bleeding Sequence | BLEEDING THE BRAKE SYSTEM | |
| Disc Brakes | SPECIFICATIONS | |
| Torque | TIGHTENING TORQUES | |
| Charging | ||
| Generator | SPECIFICATION | |
| Torque | See specific procedure under REPAIR INSTRUCTIONS . | |
| Drive Belts | ||
| Adjustment | NA | |
| Belt Routing | See procedure in DRIVE BELT FOR AUXILIARIES | |
| Engine Cooling | ||
| General Service Procedures | SPECIFICATIONS | |
| Radiator Cap Pressure | 20-22 psi (140-150 kPa) | |
| Thermostat R & I | THERMOSTAT, 4-CYL | |
| Water Pump R & I | COOLANT PUMP, 4-CYL | |
| Engine Mechanical | ||
| Compression | GENERAL DATA | |
| Oil Pressure | OIL PRESSURES | |
| Overhaul | SPECIFICATIONS | |
| Torque | TIGHTENING TORQUES | |
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |
| Flywheel/Flex Plate Torque | See TIGHTENING TORQUES . Use Loctite on studs. | |
| Fuel System | ||
| Fuel Filter Location | The fuel filter is mounted in the pressure line between the fuel pump and the fuel rail at the front of the fuel tank on the right-hand side. | |
| Fuel Filter R & I | NA | |
| Pressure Release Procedure | Remove fuel pump fuse No. 15 while the engine is idling. Turn off ignition once engine has stopped. Install fuse No. 15. | |
| Pressure Specifications | 43 psi (296 kPa) | |
| Fuel Pressure Test Procedure | CHECKING THE FUEL PRESSURE REGULATOR, 4-CYL | |
| Ignition | ||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | |
| Spark Plugs | ||
| Type | NGK PFR 6H-10 | |
| Gap | .037" (.95 mm) | |
| Torque | 21 Ft. Lbs. (28 Nm) | |
| Starting | ||
| Starter | SPECIFICATIONS | |
| Torque | NA | |
| Wheel Alignment | ||
| Alignment Specifications | WHEEL ALIGNMENT | |
| Torque | TIGHTENING TORQUES | |
| Wheel & Tire | ||
| Lug Stud Torque (Aluminum) | 80 Ft. Lbs. (110 Nm) | |
| Lug Stud Torque (Steel) | 37 Ft. Lbs. (50 Nm). After initial torque, turn each lug stud an additional 90 degrees, then an additional 90 degrees to a maximum of 81 ft. lbs. (110 Nm). | |