LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2007 >> 9-3 2.0T, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Fuel System V6) >> Repair Instructions >> Control Module, Fuel Pump (697) >> To remove

To remove

WARNING: This page is about a different variant/trim than selected.
  1. 4D/5D:  Remove FRONT SEAT (2006) or FRONT SEAT (2007) or FRONT SEAT (2008) .

    CV:  Remove SEAT CUSHION, BACKREST, CV (2006) or SEAT CUSHION, BACKREST, CV (2007) or SEAT CUSHION, BACKREST, CV (2008) .

  2. 4D/5D:  Fold up the right corner of the rear carpeting.
  3. Lift up the control module slightly and unplug the connector.
    IMPORTANT: Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves straight apart to avoid bending the pins.
    Fig 1: Unplugging Connector
    G05057527Courtesy of SAAB-SCANIA OF AMERICA, INC.
  4. Cut the cable tie holding the control module to the insulation.
scientia non olet · About LEMON Manuals