LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2006 >> 9-7X 4.2i >> Repair and Diagnosis >> Body & Frame >> Windows >> Doors >> Repair Instructions >> Door Check Link Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Check Link Assembly
    GM723022Courtesy of GENERAL MOTORS CORP.
  1. Install the check link assembly through the door access hole. Ensure that the position arrow is pointing forward.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 2 check link retaining nuts to the door.

    Tighten:  Tighten the nuts to 7 N.m (62 lb in).

    3. Fig 2: Removing/Installing Rubber Dust Boot
    GM723020Courtesy of GENERAL MOTORS CORP.
  3. Install the rubber dust boot to the check link.
    4. Fig 3: Removing/Installing Bolts That Retain Check Link To Pillar
    GM723023Courtesy of GENERAL MOTORS CORP.
  4. Install the 2 bolts that retain the check link to the pillar.

    Tighten:  Tighten the bolts to 15 N.m (11 lb ft).

  5. Install the front lower window run channel. Refer to Window Weatherstrip Run Channel Assembly Replacement - Front .
  6. Install and fully seat the water deflector.
  7. Install the door trim panel. Refer to Trim Panel Replacement - Side Front Door  orTrim Panel Replacement - Side Rear Door .
scientia non olet · About LEMON Manuals